Designation: D – 99e1. Standard Test Method for. Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings1 This standard is. ASTM Dpdf – Download as PDF File .pdf), Text File .txt) or read online. Designation: D – 99An American National Standard Standard Test Method for Resistance to Short-Time Hydraulic Pressure of.
|Published (Last):||5 April 2013|
|PDF File Size:||1.78 Mb|
|ePub File Size:||3.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM D – PRESSURE TESTING OF PLASTIC PIPE
The High Asym Pressure HCP testing system offers up to two constant pressure stations and 1 burst station up to bar. One cabinet contains up to 50 up to astm d 1599 on request individual pressure stations.
Historical Version s – view previous versions of standard. For hydrostatic pressure testing astm d 1599 pipe samples by immersing samples in water at accurately controlled temperatures. For internal hydrostatic pressure testing of fittings.
ASTM D Standard test method for resistance to short-time hydraulic failure 15599 of plastic pipe, tubing, and fittings Back to overview Products: Work Item s – proposed revisions of this standard.
ASTM D 1599
For conditioning pipe samples at specified temperatures for e. For pressure testing of large PE pipe samples and fittings.
Many thermoplastics give significantly different burst strengths depending on the time to failure. The system is a modular airless pressure testing system with unparalleled accuracy no matter what astm d 1599 sample is connected to the system.
It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the 199 astm d 1599 regulatory limitations prior to use.
Procedure B is used to determine that a specimen complies with a minimum burst requirement.
For internal hydrostatic pressure testing of pipes and fittings. Link to Active This link will always route to the current Active version of the standard. The astm d 1599 closures seal off the sample in order to generate internal pressure in the sample.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Also for general use in laboratories.
SCITEQ – ASTM D
The values given in parentheses are mathematical conversions to SI units that are provided for information only and astm d 1599 not considered standard. Either the internal hydraulic pressure or the hoop stress may be listed in the requirements. The end plugs seal off the sample in order to generate internal pressure in the sample.
They are generally not indicative of the long-term strength of thermoplastic or reinforced thermosetting resin pipe, tubing, and fittings.
The BASE unit is an all-in-one pressure testing unit with integrated high pressure pump and up to 5 independent pressure stations. Data obtained by this test method are of use only in predicting the behavior of pipe, tubing, and fittings under conditions of temperature, astm d 1599, method of loading, and hoop stress similar astm d 1599 those used in the actual test.
For internal hydrostatic astm d 1599 testing of pipes. For preparing and conditioning pipe samples for determination of for instance rapid crack propagation RCP thermoplastics pipes and other tests. For instance, significant differences have been observed between failure times of 65 and 85 s. Standard test method for resistance to short-time hydraulic failure pressure of plastic pipe, tubing, and fittings.
Procedure A is used to determine burst pressure of a specimen if the mode of failure is to be determined. Also suitable for conditioning samples requiring controlled temperature immersion.